對于油煙凈化器的安裝方式可以有很多種，但是大體分為兩塊，即室外和室內安裝。針對于室外安裝來看，又會有低空排放和高空排放這兩個方式。下面來講講濟南油煙凈化器安裝需注意的幾個細節。

There are many installation methods for oil fume purifiers, but they are generally divided into two parts, namely, outdoor and indoor installation. For outdoor installation, there are two modes of low-altitude emission and high-altitude emission. Here are some details to be paid attention to in the installation of Jinan oil fume purifier.

油煙凈化器安裝位置同樣要考慮到他的除煙效果，達到佳效果才是重要的。我們經過反復的試驗，終了解到實踐安裝工程案例中一般把油煙凈化器裝在離集煙罩大概3-8米這樣的距離，此時的距離是油煙凈化器安裝的好的位置。另外我們還可以知道這樣可以確保消防以及凈化的效果。

The installation position of the oil fume purifier should also consider its smoke removal effect, and it is important to achieve a good effect. After repeated tests, we finally learned that in practical installation engineering cases, the oil fume purifier is generally installed at a distance of about 3-8 meters from the smoke collecting hood, and the distance at this time is a good place for the installation of the oil fume purifier. In addition, we can also know that this can ensure fire safety and purification effect.

對于油煙凈化器的安裝我們還要注意它的防護。比如是不是有雨淋，我們要做好防水和防曬的準備。在安裝的過程中，我們依然要保留好一塊空地，是便于我們進行維修的地方。相應的機箱門應保持90度以上直角自由開啟的空間，這對于我們以后的維修保養等都是很好的。

For the installation of oil fume purifier, we should also pay attention to its protection. For example, if there is rain, we should be prepared for waterproof and sunscreen. In the process of installation, we still need to reserve an open space for our maintenance. The corresponding cabinet door should be kept with a free opening space of more than 90 degrees at right angles, which is very good for our future maintenance.

在安裝油煙凈化器的時候，我們依然要有一定的細節注意，包括防護方面的，比如防腐蝕或者是防止出現碰撞等等。這些都是我們在進行安裝的時候需要充分考慮到的。安裝引風機時要考慮把它安裝在油煙凈化器之后，這樣便于依據實際情況安裝，靈活性較大一些。

When installing the fume purifier, we still need to pay attention to certain details, including protection, such as anti-corrosion or collision prevention. These are all things that we need to fully consider when installing. When installing the induced draft fan, it should be considered to install it after the oil fume purifier, so as to facilitate the installation according to the actual situation and make it more flexible.

我們一般會在油煙凈化器的管道以及引風機的相關安裝完成之后，再來安裝電路。一般的情況下油煙凈化器接220v的電源就足可以了。通電后設備電源箱旁會有紅顏色和綠顏色指示燈，一般兩個指示燈同時亮起的時候，設備就是正常工作狀態，否則的話設備就不正常運行。

Generally, we will install the circuit after the installation of the pipes of the oil fume purifier and the induced draft fan is completed. In general, it is enough for the fume purifier to connect to the 220V power supply. After power on, there will be red and green indicator lights beside the equipment power box. Generally, when the two indicator lights are on at the same time, the equipment is in normal working state, otherwise, the equipment will not operate normally.

通過上面的解釋，對于油煙凈化器安裝需注意的幾個細節大家都已經了解了。那么在一般的安裝當中，還會有很多的問題。例如有些零件不配套或者是遇到一些電路或者是裝置上的問題等等，這些就需要我們在遇到實際情況的時候進行相應的解決了。關注網站http://www.pvcbox.cn，咨詢更多事項！

Through the above explanation, we have understood several details that should be paid attention to in the installation of the fume purifier. There will be many problems in general installation. For example, some parts are not matched or some circuit or device problems are encountered. These need to be solved when we meet the actual situation. Follow the website http://www.pvcbox.cn Yes, for more information!